On this forum, a lot of the advanced usage scenario instructions seem to use duplicacy CLI. Is there an article outlining how to use both duplicacy-web and -cli in a way that they share the same config and don’t step over each other? I couldn’t find it in the FAQ, though after much gnashing of keywords I did find this article [1] which makes it seem like it’s difficult/brittle.
Could someone comment if this is a commonly supported scenario? Or is this kind of usage perhaps covered in a duplicacy-utils package?
[1] CLI and WebUI - why don't they know each other?
Edit:
I also found this [2] and was reminded of my original questions:
- “Are configs compatible between -web and -cli usage”
OR - "Can a
.duplicacy
folder beln -s
'ed to the corresponding~/.duplicacy-web/sub/tree
"